Home Decor Build a garden pond

tomarnidhi · Mar 4, 2013

Ponds are probably the single most important wildlife feature that can be added to a garden, attracting a host of creatures from birds, to frogs and beneficial insects.

Before you start

It's easy to create a simple pond in your own garden. Always consider the following:

The view of the feature from every angle of the garden and house.
The type of pond - will you use a liner or a preformed pool?
The size of the pond.
The type of plants you wish to grow. Different plants require different depths of water.
Avoid shady areas, especially near deciduous trees.
Seek professional advice when constructing complicated designs and using electricity to operate pumps.

What to do

Time needed

Depends on the size of the pond

You will need

Craft knife
Hose - for marking out shape
Plank - long enough to reach over pond
Spade
Spirit level
Wooden pegs
Butyl liner
Pond insulation liner or old carpet
Canes
Paving or turf for edging
Soft building sand

Marking out

Define the perimeter of the pond, either with string, a length of hosepipe, or by trickling a layer of dry sand through your fingers.
Remove the turf from the area and stack neatly away from the working place.

Digging

Excavate the area with a spade to the depth of the first shelf. Mark the outline of the shelf with sand or string.
Dig out the centre of the pond and either add additional shelves, or dig until the required maximum depth has been reached.
Check each shelf is level.

Wildlife in mind

Move the dug-out soil to another area of the garden.
Check the sides of the pond following the profile you intended. It's a good idea to give one side of the pond a gentle slope to offer animals a means of escape if they fall in.

Lining the pond

Remove any lumps or sharp stones from the hole. Then spread a 3cm (1.2in) layer of soft builder's sand over the area. This will help protect the butyl liner being punctured.
A layer of pond underlay or old carpet above the sand will provide additional protection.
Get a friend to assist in unfolding the butyl liner. Spread it evenly over the hole taking care not to damage it by dragging it on the ground. Secure the sides of the liner with bricks.

Filling up

Start filling the pool with water and pull the edges of the liner so that it fits neatly over the contours of the pond.
Continue filling the hole with water until the pond is full.
Trim the sides of the liner leaving a 30cm (12in) overlap around the sides of the pond.
Cover these with paving slabs, or if you want to create a more natural effect, lay turf up to the water's edge.
The liner should be covered to prevent sunlight causing it to perish. Position plants and add oxygenators. If you want to add fish wait six weeks until the plants are established.

Pond safety

According to studies, children below the age of five are most at risk of drowning in garden ponds. The only way to avoid potential disasters is to not have a pond. There are, however, precautions that you can take to significantly reduce the chance of accidents.

Rigid steel mesh frames can be positioned securely over ponds. These can be obtained from security grille suppliers and metal stockholders who should be able to cut the mesh to size. Mesh should be heavy duty, ideally made from 6mm to 8mm diameter wire. Secure it firmly and it should support the weight of a young child. Ideally the mesh should be positioned above the water level.